![]() ![]() ![]() Note: Hard drives should never be configured as a Slave device to a CD-ROM or DVD drive.Ĭable Select (CS) is an alternative - plug and play - method for configuring ATA or ATAPI devices. A Slave device should always be attached to the middle (gray) connector on the ribbon cable. If the drive is going to be installed as a secondary device to another hard drive, then use the Slave setting outlined in the jumper diagram. ![]() Just keep in mind that the Master device should always be attached to the end (black) connector on the Ultra ATA (UDMA) ribbon cable (this cable is supplied with your retail box). If the drive is going to be installed as the only device on the ribbon cable, or is going to be installed as the boot drive, then the default Master setting can probably be used without any problems. Seagate and Maxtor ATA drives ship directly from the factory configured as a Master device. Under most conditions the standard Master or Slave setting should work just fine. Master, Slave, or Cable Select - Which jumper settings should I use? Overview and details for DiamondMax 10 (PATA 133) drives, including model numbers and specifications. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |